If you have been wondering whether it’s possible to install metal roofing over shingles, you should know that it’s possible.
The main advantage of installing the metal roofing is that the roof tends to have a long lifespan; therefore, once you install it you don’t have to keep on installing it over and over again.
To install the roof you need a measuring tape, Roofers - You Get What You Pay For When Hiring a Roofing ... Anita IA 50020 a chalk line, and snips to cut the metal.
Once you have these tools you should start by measuring the height and width of the roof. The sole aim of measuring the roof is to determine the amount of metal that you need. When measuring you should ensure that you include 2-4 inches of overhang.
Once you have the measurements you should head to Anita IA 50020 the stores to buy the roofing. The best roofing that you should go for is the V-crimp roofing. The good side with this roofing is that you don’t need to use lap screws which makes the installation process very easy.
To ensure that the roofing materials fit in place perfectly, you should ensure that you install slat boards over shingles. For ideal results Metal Roofing Four Way Interlocking Permanent Steel Roof System Anita IA 50020 you should ensure that the boards are 24″ apart.
When you complete installing the boards you should now install the metal roofing over the slats. Installing the roofing is easy. This is because all you need to do is to screw the roofing into slats.
Once the first sheet is in place you should now install the second sheet. Here you need to overlap Anita IA 50020 the second sheet on the first bubble and screw it in place.
You should continue doing this until the entire roof is complete. When you reach the last sheet, you should measure it and ensure that you allow an overhang that goes just beyond the peak of the roof.
You should mark where you want the roof to reach and then using tin snips Anita IA 50020 cut off all the extra material across the entire sheet. After doing this you should screw the last sheet in place.
Once all the metal sheets are in place you should now put on the metal edging which aids in covering the sides of the roof. The edging also covers the roof peak. For the edging to fit on both sides of the Anita IA 50020 roof you need to notch the edging in the center.
When it comes to roof edging you should screw in the bottoms every 24″ using wood screws. For ideal results you should insert the screws on either side near the high point of the roof, but not at the very top.